Home     Shop Index     Terms & Conditions     Advanced Search     Shopping Basket     Checkout      Contact Us     Login
 

Remote Light Sensor Remote Light Sensor Ref: PY397
Remote light sensor allows doorkeeper to be positioned inside the poultry house.

To be installed inside, or where there is restricted daylight.
a) Remove the clear plastic cover by unscrewing the 4 corner plugs. Mount the unit above the sliding gate by using 4 screws or bolts (Not supplied) The cord loop of the Doorkeeper should be centred above the sliding gate, do not cut the knot off the cord, this knot is used to “stop” the gate when it opens Do not fit the batteries at this stage.

b) Open the sliding gate to a maximum of 50 cm and in this open position; fasten it to the pull cord. This fixes the sliding gate in the open position. The lower stop will be automatically "chosen" by the doorkeeper.
C) Cover the Circuit board light sensor (R2) with the black cap supplied. Install the outsidelight sensor bulb (long grey cable with bulb
sensor) in a submerged manner in an outside wall and seal it by silicone compound. Fit the outsidelight sensor cable onto the pins 5 and 6 of the doorkeeper

d) Fit the 4 AA batteries (supplied) into the holder, carefully ensuring the correct polarity.
The blue wire should be connected to pin 1A (blue spot) and the red wire to pin 2A (red spot)
e) Refit the clear plastic cover. If you are fitting a timer refit the cover later.


90cm cable and fixings included.

Price: £9.99 (Including VAT at 17.5%)




Back to previous page